Sat-Light 7410F Guida Utente Scaricare il pdf (Pagina 51)

7410F IFL Installation and User’s Guide Appendix IV 7100M Chassis

Foxcom Proprietary Information 51

Document No. 93-006-01-A

Figure 31 - 7100M Chassis Rear View

9.2.4. Connecting the Back Panel Jumpers

On the rear panel of the 7100M Back Panel are product connectors (JP1 to JP4). The 3 pin connectors (male) are the

connecting point between the slots and the back panel. One pin is for the Tx/Rx, one is for the 2000 RF Switch, and one is

for the 7100M. A 2 pin jumper (female) is placed on the relevant pins to complete the connection between the 7100M and

the units. For example, if a 2000 RF Switch is being used, the jumper is placed on the Switch-7100M pins.

To connect the jumpers:

1. Each jumper has two sets of pins, upper and lower. The upper pins are labeled SW (Switch) and the lower pins Tx/Rx

(Transmitter/Receiver).

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 73 74

Nessun commento

Sat-Light 7410F Guida Utente Pagina 51